Knob & Tube and Aluminum Wiring Replacement services
- Knob and tube identification and removal
- Aluminum branch wiring replacement
- Approved aluminum-to-copper pigtail remediation
- Ungrounded outlet correction throughout the home
- Attic and wall wiring replacement with minimal damage
- Insulation-safe rewiring for attics
- Written reports for insurers and buyers
- Panel evaluation and upgrade if needed
Every project in California starts with a thorough inspection of accessible attic, crawlspace and wall wiring. We document what is active, what is abandoned, and where connections show heat damage. From there we build a phased plan that replaces the risky wiring first and keeps your family's routine intact.
Aluminum wiring does not always require full replacement. In many California homes, correctly installed connectors at every device and junction bring the system to a safe condition at lower cost. We explain both routes honestly. Homeowners in Los Angeles, San Diego and San Jose and across California have relied on that straight advice.
Look for these signs in older California homes
- Ceramic knobs or tubes visible in the attic or basement
- Wire stamped AL or ALUMINUM on the jacket
- Warm cover plates or a plastic smell at outlets
- Flickering lights that no bulb change fixes
- Two-prong outlets throughout the house
Frequently asked questions
Is knob and tube wiring illegal in California?
It is not illegal to have, but it cannot be extended, and most insurers want it replaced. We remove it and install modern grounded circuits in California homes.
Can aluminum wiring be repaired instead of replaced?
Yes, in many cases. Approved copper pigtailing at each connection is an accepted remediation. We will tell you which option fits your California home.
Will replacing old wiring damage my walls?
We fish wire wherever possible and keep openings small and documented. Most California homes need only minor patching.